Lead tape is intended to increase a club’s swing weight by adding weight. Theoretically, it can assist you in making longer, straighter swings than a lighter club. Additionally, depending on your miss and preferred shot form, you can apply it in a variety of ways.
So you need to be aware of how much additional weight is added to the shaft after adding a lead tap to it to make sure that it does not cause ending your shots with the wrong aim and distance.
In this article, we discuss how to use lead tape correctly on the shafts mainly focusing on the weight of the lead tape. So stick around until the end to find out what you’ve been looking for. Welcome to Sportic Media.
Table of Contents
How to use lead tape on golf clubs?
A 1-inch strip of lead tape normally weighs about 1 gram, thus there are many different methods to apply it to a golf club in order to increase the swing weight of the club. Therefore, the additional weight can, in principle, help you hit the ball longer and straighter in addition to fixing a typical miss or altering shot shape.
Making sure the area is clean is crucial before applying lead tape on the club. To make sure the area is flat, lightly sanding it with sandpaper can be helpful. Use a golf ball to smooth up the tape after you’ve applied it to the desired area.
The places that you have to apply the lead tape differ from situation to situation. So the following are the type of shafts and the places to apply lead tapes on each type of shaft.
When adding lead tape to irons, it is advised to place the lead tape at the region that will be bearing the majority of the weight. In order to enhance the weight of the clubhead for better accuracy, professional golfers typically tape lead immediately behind the middle part.
Lead tape is placed precisely behind the middle of the wedge since you don’t shape your wedge shots. Thus, the larger swing weight can enhance ball striking and flight. Some professionals think that lowering the lead tape on the club will also aid in boosting the launch.
Sole of Putter: Applying lead tape to the putter’s sole will aid players who have trouble opening or closing the putter face by helping the putter square up upon impact.
When playing on slower greens, Tiger frequently inserts lead tape behind the center of the club head. The extra weight helps him make accurate putts.
Shaft: To increase the speed of the stroke overall, players will occasionally tape the shaft.
The majority of professionals will place a piece of lead tape exactly behind the center of the iron, adding weight for accuracy. Nevertheless, applying tape on the heel or toe is undoubtedly popular, according to shot shape.
Place the lead tape directly into the cavity in the center of the club if you are using cavity back irons. Depending on the desired shot shape, adjust the heel or toe.
Are you hitting the ball too low or do you need more forgiveness?
You can successfully drag the CG (center of gravity) farther rearward by wrapping a piece of lead tape across the back of the sole, away from the face. The driver will get more highly spinning and highly launching as a result. A driver that is easier to hit straight and launch high will be the outcome.
Too much spin or hitting the ball too high?
Apply lead tape to the sole’s front section next to the face. As a result, the CG will be dragged low and forward, reducing spin rates and lowering the ball’s trajectory. Be careful because this lead tape positioning may lessen forgiveness, emphasizing center hits more.
What is the weight of lead tape on golf clubs?
According to its thickness, lead tape weighs between 1.8 and 2 grams per inch. This is roughly equivalent to one swing weight, so be careful not to use too much lest you significantly alter the balance point and feel of the club as a whole.
How much does lead tape affect swing weight?
A golf club’s swing weight will be increased by adding lead tape, giving the swing a greater sense of “heft.” For that purpose, a 4-inch-long, half-inch-wide strip of lead tape will elevate any club’s swing weight by one point, or from D0 to D1.
How much do 2 inches of lead tape weigh?
Although there are no precise measurements available, it is widely agreed that a strip of lead tape that is 2 inches long and 1/2 inch wide weighs about 2 grams.
How much does lead tape cost in golf clubs?
As there are a lot of brands in the market, a lead tape will be in the 10$ to 50$ range. But as custom-fitted golf clubs are now available in the market, the use of lead tape has been reduced to some extent. But still, some players and coaches use lead tape to save money in the process.
It is totally your choice to use lead tape or not in the game and if you use t you should prefer what your coaches say.
Some related FAQs.
How much lead tape is a swing weight?
The solution is lead tape. You’ll be alright if you put it on your sole or wrap it around your head. But keep in mind that one swingweight point corresponds to each 4-inch-long strip of half-inch-wide lead tape.
Do pro golfers use lead tape?
Many tour professionals wrap their clubs in lead tape to change the weight, feel, and trajectory of the ball as well as to correct swing flaws. Despite the expansion of weight-adjustability capabilities in contemporary drivers, it is important to recognize lead tape’s continued dominance in the game today.
Where do you put lead tape on a driver to reduce spin?
Lead tape can be added further up the back of the clubface to assist prevent excessive spin and make the ball easier to control. Tour professionals frequently use lead tape on their wedges.
Discover the meticulous and expert-driven process behind our product reviews at Sportic Media. Our comprehensive guide, led by industry veterans, ensures you get the most reliable and detailed insights into golf equipment. Dive into our methodical approach by visiting How We Test Products at Sportic Media: A Comprehensive Guide